Filter
Top Products
Electrical information - AT-200
Each toaster is equipped with a 4 foot (122 cm), 3 wire grounded power supply cord which terminates with a
3 prong plug (6-50P).
MODEL NUMBER
AT-200
Overall Dimensions with Superfeeder
Stock Number/Electrical
Productivity (Fresh Product)
Bun Halves per hour
Bread/toast sliced per hour
Croissants per hour
English muffins per hour
Net/Shipping Weight
18 3/8"H X 15 3/4"W x 26 1/2”D (46.7 cm x 40 cm x 67.4cm)
208V-5600W-27.0 amps
230V-5145W-22.4 amps-50 Hz
240V-5600W-23.4 amps
( 208V/240V )-1200
( 208V/240V )-1400
( 208V/240V )-1400
( 208V/240V )-1000
68 Lbs./75 Lbs. (30.9/34.1 kg)
A. UNPACK UNIT
1. Remove unit from shipping carton, unwrap loose parts and remove any packing tape.
2. Refer to the illustration below and account for the following parts:
a) (4) legs - wrapped, internal package
b) Bread Slide - shipped in place
c) Bread Drawer - shipped in place
d) Reflector/Crumb Tray - shipped in place
e) Superfeeder (optional) - wrapped, internal package
f) Instruction manual -wrapped, internal package
INSTALLATION - AT SERIES
Superfeeder
Reflector/Crumb Tray
Bread Slide
Bread Drawer
Studs
Legs
B. ASSEMBLY
1. Lay the toaster on its side and install
four adjustable legs into threaded
holes in base. Tighten legs with
crescent wrench. The unit may be
leveled by unscrewing the lower
insert of each leg. Precise leveling is
not required for proper operation of
the toaster. Set the toaster upright.
CAUTION: DO NOT OPERATE THE
TOASTER WITHOUT THE LEGS
INSTALLED.
2. Refer to the illustration and check that the Reflector/Crumb Tray is in the proper position.
CAUTION: DO NOT OPERATE THE TOASTER WITHOUT, THE REFLECTOR/CRUMB
TRAY IN POSITION UNDER THE CONVEYOR CHAIN.
3. Check that the Bread Drawer is positioned flat on toaster base and pushed to ths rear until it
stops. (Note: Bread Drawer is installed or removed by lifting the front handle at an angle so
that the rear edge of drawer slides under the two front internal studs on right and left sides of
toaster walls.)
4. Check that the Bread Slide is situated internally so that the '''tabs'' on each side are' resting
behind the two rear internal studs on right and left sides of toaster walls. The front edge of
the Bread Slide rests on top of the two front internal studs on right and left sides of the toaster
walls. The Bread Slide should be covering the rear portion of the bread drawer.
5. Attach the optional Superfeeder on the, rod and pins located in front of the conveyor belt as
shown in the illustration.
11