Filter
Top Products
TABLE OF CONTENTS
GENERAL INFORMATION AND TROUBLESHOOTING 2
M SERIES - DIAGONAL CONTACT CONVEYOR TOASTERS 3-9
Electrical Specifications 3
Installation 3
Location 6
Operating Instructions 6
Field Adjustments & Cleaning 7
Troubleshooting Guide 9
AT SERIES - HORIZONTAL RADIANT CONVEYOR TOASTERS 10-13
Electrical Specifications 10
Installation 11
Convertible Instructions 12
Operating Instructions 13
BT-15 SERIES 14-16
Electrical Specifications 14
Installation 14
Operating Instructions 15
WARRANTY IN FORMATION 19
GENERAL INFORMATION
General Installation:
1. Always clean equipment thoroughly before first use. (See general cleaning instructions).
2. Check rating label for your model designation & electrical rating.
3. Locate equipment on level counter and plug into a grounded outlet so that the plug is accessible.
(See individual description for electrical loads).
4. On units bearing the CE marking, the appliance must be connected by an earthing cable to all other
units in the complete installation and then to an independent earth connection.
GENERAL TROUBLESHOOTING
Always ask & check:
1. Is the unit plugged in?
2. Check circuit breaker.
3. Is power switch on and pilot light glowing?
4. Check rating label. Are you operating unit on proper voltage?
5. If the supply cord is damaged it should be replaced by an identical supply cord.
If the above checks out and you still have problems, call an APW Wyott authorized service agency.
2
!
!
WARNING: In Europe, appliance must be connected by an earthing cable to all other units
in the complete installation and thence to an independent earth connection in compliance
with EN 60335-1 and/or local codes
!
!
WARNING: An earthing cable must connect the appliance to all other units in the complete
installation and from there to an independent earth connection.