Aquatic SYMPHONY SERIES Dishwasher User Manual


 
Aquatic Industries, Inc.
12
PARTS INCLUDED FOR INSTALLATION:
4 - Spring clips
8 - #6, ½” self tap screws for spring clips
3 - #8, 1¾” stainless steel screws
(use 2 for 5’ skirts, 3 for 6’ skirts)
3 - Chrome decorative caps
3 - Brass decorative caps
3 - Decorative cap holders
9 - Decorative caps in assorted colors with attached cap holders
1 - Instruction sheet
If any of the above parts are missing from your package, contact Aquatic Technical Department at (800) 928-3707.
TOOLS REQUIRED FOR INSTALLATION: (NOT INCLUDED)
Phillips Head Screwdriver
Belt Sander
Fine-Tooth Saw
Wood Blocks
Pencil
Safety Glasses
Square/Level
Gloves
FLAT PANEL SKIRT INSTALLATION INSTRUCTIONS
PLEASE READ INSTRUCTIONS BEFORE PROCEEDING WITH INSTALLATION
NOTE: The skirt panel may require re-sizing to fit the specific installation. Carefully take your measurements so
that the skirt will fit the skirt opening. If re-sizing is required, it is suggested that the skirt is measured and marked
to the required dimensions. Cut to within 1/8” of finished dimensions using a fine tooth saw. Use a belt sander to
remove the remaining material to the finished size. The skirt could be damaged if improper procedures and/or tools
are used. It is important to follow all the steps in this installation procedure. If additional guidance is required, you may
contact the Aquatic Technical Department at (800) 928-3707.
FLAT PANEL SKIRT INSTALLATION INSTRUCTIONS
1. Remove the wood strip (on some models) from the structural support. DO NOT REMOVE the structural support.
(SEE DETAIL VIEW A ON PAGE 13).
2. Locate the raised lip support channel beneath the lip of the bath tub as shown in FIGURE 1 ON PAGE 14. NOTE:
Some models do not have the lip support channel running the full length of the tub. These tubs will need to have
blocks of wood glued (construction cement) to the underside of the tub so that the spring clips can be attached.
3. Place the spring clips at even intervals along the support channel, use all four clips. Position the front of the clip
to line up with outside of the bath lip, (SEE FIGURE 4 ON PAGE 14) making sure they line up properly. Mark the
hole openings for the screws with a pencil. Place a #6, 1/2” screw at the marked position and secure the clips
to the channel. Use 2 #6 screws for each clip as shown in FIGURE 1. Make sure the screws go into the support
channel or into the wood blocks.
4. Slide upper side of skirt (SEE FIGURE 4) under the lip of the tub. Align the offset edge of the skirt so it is parallel
with the bottom of the bath lip (SEE FINAL ASSEMBLY DIAGRAM ON PAGE 14). The panel should slip into place
between the lip rim and the four spring clips (SEE FIGURE 4). While holding skirt at the bottom, move it inward
toward the tub (SEE FIGURE 2). The vertical edge of the skirt should be aligned perpendicular to the floor (SEE
FINAL ASSEMBLY DIAGRAM).
SEE FIGURE 2 AND FINAL ASSEMBLY. To secure the bottom of the skirt, wood blocks (2 for 5’ skirts or 3 for 6’ skirts),
will need to be anchored to the floor. Use a level (that is held against the outside face of the tub lip and touching the
floor) at each pre-drilled hole location to mark where the face of the skirt panel will be aligned. Subtract the thickness
of the skirt and the structural support to position the wood blocks. Anchor the blocks to the floor, then screw the 1¾”
#8 screws, through the decorative caps and the pre-drilled holes, into the wood blocks.