Filter
Top Products
- 20 -
SAFETY PRECAUTIONS
The following safety precautions should be followed when operating any
appliances:
! Always disconnect the power cord before attempting to work on or clean any
equipment.
! Disconnect the power cord when the appliance will be idled for a long period
of time.
! Do not attempt to service this unit yourself as removing any covers may
cause exposure to dangerous voltage.
! Always route the power cord so that it is not likely to be walked on or
pinched by other appliances. Never use extension cords.
! Do not overload outlets with more than one appliance. This can result in fire
or electrical shock.
! Your model is equipped with a grounded and polarized plug. Do not defeat
the purpose of this plug by removing the ground post or using a non-
polarized adapter without properly grounding the outlet.
! Never connect any appliance to a power source while standing in water or
with wet hands.
! When a replacement part is required, always insist on factory authorized
parts only.
MAINTENANCE
PERIODIC CLEANING PROCEDURE
It is best to clean your refrigerator or freezer when the product load is at its lowest
level inside your cabinet. To clean the interior or exterior cabinet surfaces, the
following procedure should be followed:
1. Disconnect your model from its power supply and remove all food product from
inside.
2. Open all doors and allow the cabinet to reach room temperature. Remove all
accessories (shelves, racks, pilasters, clips, etc.) From within the model, wash
with a baking soda and warm water solution, and rinse thoroughly with clear
water. Dry all of the accessories completely with a soft clean cloth.
3. Once the cabinet has reached room temperature, wash the entire cabinet
inside and out with a baking soda and warm water solution. For slightly more
difficult cleanups, ammonia or vinegar in warm water can be used. Rinse
thoroughly with clear water and dry with a soft clean cloth. Failure to dry all
surfaces completely may cause water stains or streaking on the aluminum or
stainless steel finish.
4. Return all accessories to their respective positions and return electric supply
power to the model.