Filter
Top Products
- 5 -
Important Note: It is extremely important that your new reach-in or roll-in
model is perfectly level for proper operation. If it is not level, the following
adverse conditions will become apparent:
1. The door(s) will not be properly aligned and consequently will not provide a
good seal. Roll-in door wiper(s) may bind.
2. Your model will run excessively due to improper door seal(s).
3. An excessive amount of ice will accumulate inside the cabinet, around the door
opening(s) and especially on the finned evaporator coil. If allowed to continue,
ice will eventually block the coil and the model will fail. This will result in the
loss of all food stored within the cabinet.
4. Defrost water will fail to drain properly and will overflow the evaporator coil drain
pan and into the cabinet of both refrigerator and freezer models.
INSTALLING CASTERS AND LEVELING REACH-IN MODELS
If you wish to install casters on your new reach-in model, follow the steps above for
"installing legs" to install the casters, making sure again that the casters are
tightened extremely well (see figure 3). If the casters are not installed tightly, the
cabinet will sway or rock with each opening or closing of the doors, possibly
causing damage to the case bottom.
To assure that your cabinet is level, caster cups must be installed under the casters
which need leveling. Caster cups are not provided with your new model but can be
purchased at most hardware or furniture stores. Do not attempt to level casters
by unscrewing them from the case bottom as this will cause damage to the
cabinet bottom and leg hole threads, voiding all warranties.
FIGURE 3
CASTERS MUST BE TIGHT TO CABINET BOTTOM