Filter
Top Products
19
· Turn on the water tap and plug in the
appliance.
· Open the door and load the dishwasher.
Check that both the upper and lower sprayer
arms can move freely.
· Add the appropriate amount of detergent to
the dispenser and close the door.
· Use the On/Off button to switch the appliance
on.
· Check the control indicators for salt
(17)
and
rinse aid
(15)
. Refill salt and rinse aid if required.
· Use the programme selection button to select
your washing programme as shown in the
programme table (see page 22).
- The duration of the selected programme is
shown in the display
(12)
.
- If required, you can use the option buttons
(
10
&
2
) to adjust the washing programme to suit
your needs.
· Use the Start/Stop button to start the
programme.
Warning !
Avoid opening the door during the washing
process. This interrupts the washing process,
and hot steam will escape. Close the door
to continue the programme.
· When the washing programme has finished,
the corresponding symbol lights up; the
remaining time indicator now shows 00:00.
· Shut off the appliance by pressing the On/Off
button
· Close the water tap and unplug the device
from the mains.
· Allow your dishes to cool for 15 minutes with
the door open. Unload the dishes, starting with
the lower basket.
Using Your Dishwasher
You can select the program you like after turning on
the machine by pressing On / Off button. Select the
program you would like to operate by pressing
program selection button. You can follow up the
program you are in from the program display on the
screen. The program number on the display will
increase one by one as you keep on pressing the
program selection button. The selected washing
program will start operating when you press Start /
Pause / Cancel button. As the program starts up, the
estimated remaining time until the end of the program
will be shown by the time display. Total time of
program may be different from the one displayed
initially as the time of washing will vary depending
on the room temperature, supplied water temperature,
reprocessing the water softening unit (regeneration)
and amount of the dishes.
Programme selection
You can run program by activating Half Load , Extra
Drying
and Time Delay functions by using the
function buttons. To add a function to the program:
1.Select a program by pressing Program selection
button.
2.Press the button of the function you want to activate
and be sure that the lamp of the relevant function
display lights on the screen.
3.You can start your program by pressing Start /
Pause / Cancel button.
Operation of the machine will not change even if the
extra drying function is selected in the Pre-wash,
Economy 50°C, and Automatic Wash 40°C-65°C
programs.
Adding Function to the Program:
You may delay the startup time of the program you
select up to 24 hours. Delay cannot be set after the
program is started. To adjust the delay time, the
selected program must not be started.
When any of the time delay buttons is pressed, Time
Delay Active Indicator
starts flashing. Set the desired
time by pressing (+) or (-) buttons. Press Start / Pause
/ Cancel button after completion of time setting. The
Time Delay Active Indicator will light on the screen
throughout the countdown for the delay, meanwhile
the remaining time will be shown on the time display.
The program will automatically start as soon as the
countdown comes to an end.
If there is any economical power tariff in your area
fixed for certain periods of time, you may benefit
from the Time Delay feature.
Time Delay