Filter
Top Products
7
When deciding on where to install your new
dishwasher, ensure that the position of your
dishwasher makes it easy and quick for you to
place the dishes in the dishwasher and also to
take them out and store away after the
dishwashing is completed.
Avoid placing the dishwasher where the ambient
temperature is likely to fall below. 0 degrees
C. (32° F)
When positioning your appliance, take care not
to damage your flooring, pipes wall coverings
etc. Do not move the appliance by pulling by
the door or handle
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily accessible
position.
Should the mains lead of the appliance become
damaged or need replacing at any time, it must
be replaced by a special purpose made mains
lead which can only be obtained from a Beko
Authorized Service Agent.
If the supply cord or the mains lead is damaged
please do not replace it by your own. The
supply cord or the mains lead must be replaced
by a Beko Authorized Service Agent personnel
or a similarly qualified person.
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
Destroy the old plug, which is cut off as a plug
with a bared cord could cause a shock hazard
if inserted into a socket elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse need
to be replaced an ASTA approved BS1362 fuse
of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing
the fuse cover, the plug must not be used until
a replacement fuse cover has been fitted.
Colour of the replacement fuse cover must be
the same colour as that visible on the pin face
of the plug. Fuse covers are available from any
good electrical store.
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals on
your plug, proceed as follows:
1 Connect the green - yellow or green (earth)
wire to the terminal in the plug marked E or
with the symbol or coloured green and
yellow or green.
2 Connect the blue (neutral) wire to the terminal
in the plug marked N or coloured black.
3 Connect the brown (live) wire to the terminal
in the plug marked L or coloured red.
With the alternative plugs a 13A fuse must be
fitted either in the plug or adaptor or in the
main fuse box. If in doubt contact a qualified
electrician.
L
Brown or red
N
Blue or
black
Green and yellow
or green