Filter
Top Products
EN
10
Reversing The Door
Follow the step by step instructions and the
diagram below. Numbers in brackets refer
to diagrams.
1.Switch off at the socket outlet and pull
out the mains plug.
2.Remove all food, loose items and
fittings from inside the appliance and door
shelves.
3.Carefully tilt the appliance on its back
side. (1) (You may need somebody to
help you.) Take care not to damage the
appliance by laying on some protective
material (e.g. its original packaging). Make
sure that you tilt the appliance on its
back side, otherwise compressor oil may
block the pipes and you may damage the
appliance.
4.Unscrew and remove the LHS front feet
and bolt (2).
5.Unscrew the bolts and remove the
bottom hinge while holding the door (3).
6.Remove the door carefully from the top
hinge by sliding down wards (4).
7.Reposition top hinge bushing and
blanking plug on the opposite side and
stand the door safely (5). You may find it
easier to remove the bushing and the plug
with the tip of a small screwdriver. Take
care not to mark the door.
8.Reposition the top hinge on the
opposite side (6 and 7).
9.To refit the door, locate the top hinge in
the door, attach to the cabinet and hold
the door (8).
10. Fit the bottom hinge (9). If necessary
adjust and then tighten the bolts.
Ensure,that the door opens and closes
easily and that there are no gaps allowing
air into the cabinet. If there are gaps
between the door seal and the cabinet,
adjust the door seal by gently pulling away
from the door using fingers.
11.Fit the other front feet (10).
12.Carefully stand your appliance. (You
may need somebody to help you.) Adjust
the front feet (See Installation Instructions)
13.Put back all, loose items and fittings.
14. Wait for at least 4 hours to allow the
system to settle before switching on.