Filter
Top Products
EN
7
Electric connection
Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
Important:
• The connection must be in compliance
with national regulations.
• The power cable plug must be easily
accessible after installation.
• The specified voltage must be equal to
your mains voltage.
• Extension cables and multiway plugs
must not be used for connection.
B A damaged power cable must be
replaced by a qualified electrician.
B Product must not be operated before
it is repaired! There is danger of electric
shock!
Disposing of the packaging
The packing materials may be dangerous
for children. Keep the packing materials out
of the reach of children or dispose them of
by classifying them in accordance with the
waste instructions. Do not dispose them of
along with the normal household waste.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old machine without giving
any harm to the environment.
• You may consult your authorized dealer
or waste collection center of your
municipality about the disposal of your
refrigerator.
Before disposing of your refrigerator, cut
out the electric plug and, if there are any
locks on the door, make them inoperable
in order to protect children against any
danger.
Adjusting the feet
If your refrigerator is unbalanced;
You can lever your refrigerator by turning
the front feet as shown in the illustration
below. The corner where the feet exists is
lowered when you turn it in the direction of
black arrow and raised when you turn in
the opposite direction. Getting help from
someone to slightly lift the refrigerator will
facilitate this process.
Placing and Installation
1. Install your refrigerator to a place that
allows ease of use.
2. Keep your refrigerator away from heat
sources, humid places and direct sunlight.
3. There must be appropriate air ventilation
around your refrigerator in order to achieve
an efficient operation.
If the refrigerator is to be placed in a recess
in the wall, there must be at least 5 cm
distance with the ceiling and at least 5 cm
with the wall.
If the floor is covered with a carpet, your
product must be elevated 2.5 cm from the
floor.
4. Place your refrigerator on an even floor
surface to prevent jolts.
5. Do not keep your refrigerator in ambient
temperatures under 10°C.