Filter
Top Products
EN
6
3 Installation
B Please remember that the manufacturer
shall not be held liable if the information
given in the instruction manual is not
observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any jolt
before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the rules of
transportation printed on the package
must be followed.
Please do not forget…
Every recycled material is an indispensable
source for the nature and for our national
resources.
If you wish to contribute to recycling the
packaging materials, you can get further
information from the environmental bodies
or local authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1. Is the interior of the refrigerator dry and
can the air circulate freely in the rear of it?
2. Empty any water in the drain tray before
moving see section “Defrosting” and
“Cleaning & Care” for further information
IMPORTANT : Make sure the plastic
evaporating pan at the back of the product
collects water properly.
IMPORTANT: Care must be taken while”
cleaning / carrying the appliance to avoid
touching the bottom of the condenser
metal wires at the back of theappliance as
you might injure your fingers and hands.
3. You can install the 2 plastic wedges as
illustrated in the figure. Plastic wedges will
provide the required distance between
your refrigerator and the wall in order to
allow the air circulation. (The illustrated
figure is only an example and does not
match exactly with your product.)
4. Clean the interior of the refrigerator as
recommended in the “Maintenance and
cleaning” section.
5. Plug the refrigerator into the wall outlet.
When the fridge door is open the fridge
compartment interior light will come on.
6. You will hear a noise as the compressor
starts up. The liquid and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor
is not running and this is quite normal.
7. Front edges of the refrigerator may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
8. The appliance must be protected against
rain, moisture and other atmospheric
influences.
“IMPORTANT: This appliance is
not designed for stacking with any
otherappliance.When positioning your
appliance, take care not to damage your
flooring, pipes,wall coverings etc.