Filter
Top Products
16
The blade assembly may be easily
removed, by inverting the blender,
pressing down on the quick release
handle, turning it counterclockwise until
it stops, as shown in figure 10a, and
then lifting up, see figure 10b.
Figure 10.
Wash the blade assembly under
running water. Do not place the blade
assembly in the dishwasher or allow it
to stand in water. This will tend to wash
out the lubricant. After cleaning, rinse
thoroughly and dry before using.
-
Figure 11.
2. To assemble or reassemble blade
assembly into the blender, insert the
blade assembly into the blender jar as
shown in figure 11, press down on the
quick release handle of the blade
assembly and turn clockwise to the
stop. The blade assembly is then back
in place.
3. If you have not already done so, remove
the motor drive cover and place the
blender on the mono drive. Turn
counterclockwise to lock the blender
in place, see figure 12a.
Placing Blender into Operation
Make sure that the switch is in the Off
position, “O/Off.” Unwind the electrical cord
to the necessary length and plug it into wall
outlet. The blender is now ready for
operation.
Figure 12.
Normally when blending, the blender jar
should be filled with the entire amount of
material to be blended, if possible, before
switching the appliance on. The cover and
cover closure should always be in place after
filling the blender jar, and before switching
the power unit to On. Any subsequent
additions to the blended material should be
made through the cover opening, see figure
13. For solids and/or granular material,
remove the cover closure/funnel to add the
material, as shown in figure 13a. For liquids,
the closure/funnel may be left in place and
the liquids added by pouring them into the
closure/funnel, see figure 13b.