Filter
Top Products
13
Use of mixing bowl with whipping whisk
Before beginning to attach this or any other
attachment, make sure that the power unit
is on a smooth, clean, suitable work
surface and switched to the Off position,
“O/Off,” and that you have the safety motor
drive cover in place of the high speed,
blender drive.
1. Before using the mixing bowl and
whipping whisk for the first time they
should be washed. See Before Using
for the First Time, on page 4.
Figure 7.
The whipping whisk, supplied with the
MCM 5200 UC, may be removed from
its holder as shown in figure 7, and
washed in the dishwasher along with
the mixing bowl and other components.
After washing, rinse well and dry the
whisk and whisk holder before
reattaching the whisk.
2. Make sure the safety motor drive cover
has been snapped into place on the
high-speed blender drive. Place the
mixing bowl on the dual drive of the
power unit, as shown in figure 4a, and
turn the bowl clockwise with a slight
downward pressure until bowl is firmly
seated.
3. Engage the whipping whisk on the dual
drive of the power unit by placing it over
the center column, as shown in figure
8. Once in place, check to make sure
the whipping whisk has engaged the
dual drive by turning the whipping whisk
counterclockwise while pushing down
until it stops.
Figure 8.
4. Next place the mixing bowl cover on
the bowl. Make sure arrows on cover
and bowl are aligned, so that tabs on
bowl fit into channels in cover and then
turn cover clockwise until tab on cover
enters cover interlock and turn until tab
clicks into place,
The cover should be in place whenever
the power unit is in operation. The cover
serves to prevent the escape of flour
dust at the beginning of the stirring
process, and also serves to prevent
accidental contact with the moving
whipping whisk. Also, the power unit
will not operate unless the tab on the
cover is in place and has engaged the
safety cover interlock.