Filter
Top Products
17
1. Before using the blender for the first
time it should be washed. See Before
Using for the First Time, on page 4.
Do not place the blender jar/blade
assembly in the dishwasher or allow it
to stand in water. This will tend to wash
out the lubricant. After cleaning, rinse
thoroughly and dry before using.
Figure 9.
9a. Cover closure/funnel
9b. Cover
9c. Blender jar/blade assembly
2. Remove the safety motor drive cover
from the high-speed blender drive.
3. Then place the mixing bowl on the dual
drive of the power unit, as shown in
figure 4a, and turn the bowl clockwise
with a slight downward pressure until
bowl is firmly seated. Next place the
mixing bowl cover, with pusher/
measuring cup in the feeding tube, on
the bowl. Make sure arrows on cover
and bowl are aligned, so that tabs on
bowl fit into channels in cover and then
turn cover clockwise until tab on cover
enters cover interlock and turn until tab
clicks into place, figure 4b.
4. Place the blender jar/blade assembly
on the high speed blender drive of the
power unit and turn clockwise to lock
in place, see figure 10a. Then place
cover with cover closure/funnel on
blender jar and turn clockwise to lock
in place, figure 10b.
Figure 10.
Placing Blender into Operation
Make sure that the power unit is on a
smooth, clean, suitable work surface and
switched to the Off position, “O/Off.” Pull
the electrical cord out to the necessary
length and plug into a convenient outlet.
The blender is now ready for operation.
Normally when blending, the blender jar
should be filled with the entire amount of
material to be blended, if possible, before
switching the appliance on. The cover and
cover closure should always be in place after
filling the blender jar and before switching
the power unit to On. Any subsequent
additions to the blended material should be
made through the cover opening, see figure
10. For solids and/or granular material,
remove the cover closure/funnel to add the
material, as shown in figure 11b. For liquids,