Filter
Top Products
14
Placing into Operation with Whipping
Whisk
Make sure that the power unit is on a
smooth, clean, suitable work surface and
switched to the Off position, “O/Off.” Pull
the electrical cord out to the necessary
length and plug into a convenient outlet.
The mixing bowl with whipping whisk is now
ready for operation. Sample recipes may
be found in the recipe section, at the back
of this manual.
Mixing bowl tips:
1. When using the mixing bowl to knead
or mix a recipe designed to be
prepared by hand, you will find that with
the Bosch Food Processor you can
usually place all the ingredients in the
mixing bowl at once. When doing this,
always place the liquids in first. This
will assure more thorough mixing.
2. When adding ingredients to a mixture:
a. Turn the rotary switch to a lower
speed
b. Remove the pusher/measuring cup
c. Add the ingredients through the
feed tube and replace the
pusher/measuring cup.
3. If a large batch of dough is to be left in
the mixing bowl and allowed to rise, the
cover should be removed and placed
loosely on the bowl so that it is free to
move if the dough should begin to press
on it.
How to Use Slicing and Grating Discs
All the MCM models comes with the mixing
bowl, cover and pusher/measuring cup and
reversible slicing disc and reversible coarse
grating disc, see figures 5h and 5i. The
MCM 5200 also comes with a fine grating
disc, as shown in figure 5g. The slicing disc
and the grating discs are intended to be
used for slicing and/or grating of vegetables,
as well slicing/grating of soft cheeses and
sausages or meat and grating of vegetables
and hard cheese.
WARNING
1. Blades on discs are sharp. Handle
carefully. Always use the center plastic
holder to lift or handle discs. Do not
grip the discs by the blades or metal
surfaces.
2. When operating using the slicing or
grating discs keep hands clear of
filling tube. Only work with pusher.
3. Always operate the power unit with
the cover in place.
Use of mixing bowl with slicing or grating
discs
Before beginning to attach this or any other
attachment, make sure that the power unit
is on a smooth, clean, suitable work
surface and switched to the Off position,
“O/Off,” and that you have the safety motor
drive cover in place of the high speed,
blender drive.
1. Before using the mixing bowl and
slicing or grating discs for the first
time they should be washed. See
Before Using for the First Time, on
page 4.
2. Make sure the safety motor drive cover
has been snapped into place on the
high-speed blender drive. Place the
mixing bowl on the dual drive of the
power unit, as shown in figure 4a, and
turn the bowl clockwise with a slight
downward pressure until bowl is firmly
seated.
3. Engage the slicing or grating disc,
by picking up the disc you wish to use,
with the side you wish to use facing
upward, by the plastic holder in the
center of the disc and placing over the
rectangular shank of the dual drive of
the power unit.