Filter
Top Products
16 17
PAGE HEADER..... PAGE HEADER.....
OPERATING
Under Extracted Zone
The gauge needle, when positioned in the
lower zone during extraction, indicates the
espresso has been extracted with
insufficient pressure.
This occurs when the water flow through
the ground coffee is too fast and results in
an under extracted espresso that is watery
and lacks crema and flavor.
Causes for under extraction include the grind
being too coarse and/or insufficient coffee in
the filter basket and/or under tamping.
Over Extracted Zone
The gauge needle, when positioned in the
upper zone during extraction, indicates
the espresso has been extracted with too
much pressure.
This occurs when the water flow through the
ground coffee is too slow and results in an
over extracted espresso that is very dark and
bitter with a mottled and uneven crema.
Causes for over extraction include the grind
being too fine and/or too much ground
coffee in filter basket and/or over tamping.
HOT WATER
• Turn the STEAM/HOT WATER dial to
the hot water position.
• Hot water will pour from the hot water
outlet and can be used for making
Americanos and pre-heating cups.
• To stop the hot water, return the
STEAM/HOT WATER dial to the
STANDBY position.
STEAM STANDBY HOT WATER
OPERATING
AUTO PURGE
Immediately after the espresso, hot water
and steam functions, the machine will purge
water into the drip tray. This ensures the
thermocoil is at the optimal temperature.
TIP
Ensure the drip tray is firmly pushed
in place and emptied whenever the
Empty Me! indicator is displayed.
SLEEP & AUTO OFF MODE
The machine automatically switches to
SLEEP MODE after 1 hour. During this time,
the POWER button light will flash slowly.
After 3 hours, the machine will switch to
AUTO OFF MODE.
To re-activate the machine, press any button
except for the POWER button. The POWER
button light will flash while the machine
re-heats. A pumping sound will be heard.
This is normal. When the machine has
reached the correct operating temperature,
the POWER button light will stop flashing
and all button lights on the control panel
will illuminate.
ADVANCED TEMPERATURE MODE
Different beans require a different water
temperature to extract their optimum flavor.
The Infuser™ allows you to adjust water
temperature ±4°F in 2°F increments from the
default temperature.
To enter Advanced Temperature Mode:
1. Press the POWER button to switch
the machine off.
2. Press & hold the 1 CUP button,
then also press the POWER button.
The machine will beep once. The
illuminated button will indicate the
current temperature selected.
To adjust the water temperature,
press the 2 CUP button to cycle
through the temperature settings.
Default Temperature setting:
Press the 2 CUP button until the POWER
button illuminates.
Decrease Water Temperature -4˚F:
Press the 2 CUP button until the PROGRAM
button illuminates.
Decrease Water Temperature -2˚F:
Press the 2 CUP button until the CLEAN
ME light illuminates.
Increase Water Temperature +2˚F:
Press the 2 CUP button until the HOT
WATER/STEAM light illuminates.
Increase Water Temperature +4˚F:
Press the 2 CUP button until the 1 CUP
button illuminates.
The machine will beep twice to confirm
the change. If no buttons are pressed
within 10 seconds after entering Advanced
Temperature Mode, no change will be made
& the machine will return to STANDBY mode.