Filter
Top Products
30 31
PAge heAder.....
CARE & CLEANING
CLEANING THE STEAM WAND
• The steam wand should always be
cleaned after texturing milk. Wipe the
steam wand with a damp cloth. Then
with the steam wand tip directed over
the drip tray, briefly set the STEAM/
HOT WATER dial to the STEAM
position. This will clear any remaining
milk from inside the steam wand.
• If any of the holes in the tip of the
steam wand become blocked, ensure
the STEAM/HOT WATER dial is in the
STANDBY position. Press the POWER
button to switch the machine off and
allow to cool. Use the pin on the end of
the provided cleaning tool to unblock
the hole(s).
• If the steam wand remains blocked,
remove the tip using the integrated
spanner in the cleaning tool and soak
in hot water. Use the pin on the end of
the provided cleaning tool to unblock
the hole(s) before re-attaching to the
steam wand.
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The filter baskets and portafilter
should be rinsed under hot water
immediately after use to remove all
residual coffee oils.
• If any of the holes in the filter basket
become blocked, use the pin on the
end of the provided cleaning tool to
unblock the hole(s).
• If the hole(s) remain blocked, dissolve
a cleaning tablet in hot water and
soak filter basket and portafilter in
solution for approx. 20 minutes.
Rinse thoroughly.
CLEANING THE SHOWER SCREEN
• The group head interior and shower
screen should be wiped with a damp
cloth to remove any ground coffee
particles.
• Periodically purge the machine. Place an
empty filter basket and portfilter into the
group head. Press and hold the 1 CUP
button and run a short flow of water to
rinse out any residual coffee.
CLEANING THE DRIP &
STORAGE TRAY
• The drip tray should be removed,
emptied and cleaned at regular intervals,
particularly when the drip tray full
indicator is showing EMPTY ME!
• Remove the grid from the drip tray. Lift
the coffee grind separator and dispose
of any coffee grounds. The EMPTY ME!
indicator can also be removed from the
drip tray by pulling upwards to release
the side latches. Wash all parts in warm
soapy water with a soft cloth. Rinse and
dry thoroughly.
• The storage tray (located behind the
drip tray) can be removed and cleaned
with a soft, damp cloth. Do not use
abrasive cleansers, pads or cloths which
can scratch the surface.
NOTE
All parts should be cleaned by hand
using warm water and a gentle dish
washing liquid. Do not use abrasive
cleansers, pads or cloths which can
scratch the surface. Do not clean
any of the parts or accessories in
the dishwasher.
CARE & CLEANING
CLEANING THE OUTER HOUSING &
CUP WARMING TRAY
The outer housing and cup warming tray
can be cleaned with a soft, damp cloth.
Polish with a soft, dry cloth. Do not use
abrasive cleansers, pads or cloths which
can scratch the surface.
STORING YOUR MACHINE
Before storing, ensure the STEAM/HOT
WATER dial is in the STANDBY position,
press the POWER button to switch the
machine off and remove the plug from the
power outlet. Remove unused beans from
the hopper, clean the grinder (see page 29),
empty the water tank and the drip tray.
Ensure the machine is cool, clean and dry.
Insert all accessories into the storage tray.
Store upright. Do not place anything on top.
WARNING
Do not immerse power cord, power
plug or appliance in water or any
other liquid.