Filter
Top Products
11
OPERATING YOUR BREVILLE DUAL BOILER™
OPERATING
your Breville Dual Boiler™
WARNING
Both the STEAM LEVER and HOT
WATER dial must be in the CLOSED
position for the machine to enter
START UP mode.
BEFORE FIRST USE
Machine Preparation
Remove and discard all labelling and
packaging materials attached to your
espresso machine. Ensure you have
removed all parts and accessories before
discarding the packaging.
Clean parts and accessories (water tank,
portafilter, filter baskets, jug) using warm
water and a gentle dish washing liquid and
rinse well.
The water filter located inside the water tank
will need to be removed before washing the
water tank.
CONDITIONING THE WATER FILTER
• Remove filter from the plastic bag and
soak in a cup of water for 5 minutes.
• Rinse filter under cold running water.
• Wash the stainless steel mesh in
the plastic filter compartment with
cold water.
• Insert the filter into the filter holder
• Set Date Dial 2 months ahead
• To install filter, push down to lock
into place.
• Slide the water tank into position and
lock into place.
NOTE
To purchase filters contact Breville
Customer Service Centre
AUS 1300 139 798 NZ 0800 273 845
FIRST USE
Initial Start Up
• Fill tank with water
• Check Steam Lever and Hot Water dial
is in the CLOSED position.
• Press POWER On.
• A pumping sound will be heard
indicating empty boilers are being
filled with water for the first time.
• Machine will reach operating temperature
and go into STANDBY mode.
Flushing The Machine
When the machine has reached STANDBY
mode, run the following 3 steps:
1. Press 2 Cup button to run water
through group head.
2. Run Hot Water for 30 seconds.
3. Activate Steam for 10 seconds.
Repeat this cycle until tank is empty.
TIP
You can maneuver your machine
about the bench using the drop down
swivel foot located under the drip tray.