Filter
Top Products
9
Assembly and operation of your
Breville Wizz™ Multi Processor
continued
8
Using the stainless steel slicing/
shredding discs
Place the disc holder spindle onto the shaft
in the processing bowl.
Fit disc onto disc holder by placing the wider
lug on end of disc, into one side of the disc
holder opening (Fig 3). Lower the disc down
over shaft hole then push disc down to lock
into position (Fig 4). To remove disc, hold disc
holder with the disc facing away and place
thumbs underneath the end of disc marked
‘Push Up’ and push out (Fig 5).
Place the disc holder onto the disc holder
spindle.
1.
2.
3.
Fig.3
Fig.4
Fig.5
WARNING: WHEN SLICING AND SHREDDING, ALWAYS USE THE FOOD PUSHER TO
GUIDE FOOD DOWN THE FOOD CHUTE. NEVER PUT YOUR FINGERS OR SPATULA INTO
THE FOOD CHUTE. ALWAYS WAIT FOR THE DISC TO STOP SPINNING BEFORE REMOVING
THE LID.
THE PROCESSING BLADE AND THE DISCS ARE EXTREMELY SHARP!! USE CAUTION
WHEN HANDLING AND STORING THESE PARTS.
Using the stainless steel processing
blade
Carefully remove the protective storage
cover from the processing blade.
Place the processing blade over the drive
shaft (see Fig 6). Rotate it slowly until
it settles into place. When handling the
processing blade, always hold by the spindle
(as shown in Fig 7).
Place the food to be processed into the
processing bowl as indicated in the recipe.
To avoid over-processing, check the
consistency frequently when the food being
processed requires a coarse or thick texture. If
necessary, turn the Speed Selection Dial to the
Off ‘O’ position, switch off at the power outlet,
unlock the lid and use the spatula to scrape
down the sides of the bowl to ensure even
processing.
Care
should be taken when removing the food
from the processing bowl by ensuring the
motor and the processing blade or disc, have
completely stopped before disassembling.
Ensure the Speed Selection Dial is turned to
the Off ‘O’ position, the appliance is switched
off at the power outlet and unplugged, before
removing the lid from the bowl. The processing
bowl should then be unlocked from the motor
body and the processing blade or disc holder
carefully removed before attempting to remove
the processed food.
1.
2.
3.
Fig.6
Fig.7
Assembly and operation of your
Breville Wizz™ Multi Processor
continued