Filter
Top Products
Food stains and odours
Strong smelling foods such as garlic, onion, fish
and some vegetables such as carrots may leave
an odour or stain on the processing bowl, lid,
disc holder, spindle and food pusher. To remove
odours or stains, soak these parts in 2 litres
of water mixed with 100ml of lemon juice or
white vinegar for 30 minutes. Then wash with a
mild detergent and warm water, rinse and dry
thoroughly.
Storage
Store your food processor on the kitchen bench
or in an accessible cupboard. Insert the discs
and disc holder into the storage container.
Insert processing blade into the protective
storage cover then onto the drive shaft in the
bowl. Place the disc holder spindle into the
bowl, insert the storage container onto the
processing blade spindle and place the lid on
top. DO NOT store with the lid locked onto the
bowl as unnecessary strain will be placed on
the operating switch in the motor base. Insert
the food pusher and measuring cup into position
in the food chute.
13
Care, Cleaning and Storage
When you have finished processing ensure the
Speed Selection Dial is turned to the Off ‘O’
position, the appliance is switched off at the
power outlet and the power cord is unplugged,
then carefully remove the lid, processing blade,
or disc holder and spindle, then the processing
bowl.
Motor base
Wipe the motor base with a clean, damp cloth
after each use. NEVER IMMERSE THE MOTOR
BASE IN WATER OR OTHER LIQUID.
Processing bowl, lid, food pusher,
measuring cup, disc holder, spindle
and spatula
Wash in warm to hot water using a mild
detergent. Rinse and dry thoroughly.
DO NOT USE STEEL WOOL, SCOURING PADS
OR ABRASIVE KITCHEN CLEANERS AS THEY
WILL SCRATCH THESE PARTS.
Do not place any part of the food processor in
the dishwasher.
Processing blade and discs
Wash in warm to hot water using a mild
detergent. Food can be dislodged from the inner
shafts of the processing blade and disc holder
spindle by inserting the end of the spatula
handle or a bottle brush.
Ensure the fine end of the processing blade or
disc holder spindle and the hole in the bowl
lid bearing, located under the white button in
the centre of the lid, are clean and free of food
residue before attaching the lid for use or for
storage.
12
THE PROCESSING BLADE AND THE DISCS ARE EXTREMELY SHARP!!
USE CAUTION WHEN HANDLING AND STORING THESE PARTS.
Care, Cleaning and Storage continued