Filter
Top Products
26
TROUBLESHOOTING
POSSIBLE PROBLEM EASY SOLUTION
• The safety locking arm may not be correctly engaged
in the vertical operating position with the locking arm
located into the two grooves on either side of the juice
cover.
• Check the Overload Protection Button on the bottom of
the Motor Base to ensure the safety device has not been
activated or the overheating protection device has not
been activated automatically, if it has, allow more time
for the motor to cool down.
Motor appears to stall
when juicing
• Wet pulp can build up under the cover if the juicing
action is too vigorous. Try a slower juicing action by
pushing the food pusher down slower. Clean the Filter
Bowl Surround, the Nutri Disc™ and the juicer cover.
Select a faster speed for harder fruits and vegetables.
• The Breville juicer will automatically stop operating if
the motor is stalled. This is a electronic safety feature.
Either too much food is being processed at one time
or the pieces are not small enough. Try trimming food,
cutting food into smaller pieces of even size and/or
processing a smaller amount per batch. If this occurs,
the light surrounding the Start|Stop button will flash
red. To continue juicing, reset the Juicer by pressing
the Start|Stop button to OFF, then clear the feed chute,
finally turn the appliance back on by pressing the
Start|Stop button to ON.
• Hard fruits and vegetables will put excess strain onto
the motor if a low speed is selected. Please refer to the
juicing guide, to determine the correct speed for the
fruits and vegetables selected on juicing.
Excess pulp building up
in the mesh of the Nutri
Disc™
• Stop the juicing process. Remove the juicer cover and
remove the pulp. Re-assemble and begin juicing again.
Try alternating (soft and hard) vegetable and
fruit varieties.
Pulp too wet and reduced
extracted juice
• Try a slower juicing action. Remove Nutri Disc™ and
thoroughly clean mesh walls with the brush included.
Rinse Nutri Disc™ under hot water. If the mesh holes are
blocked, soak the Nutri Disc™ in a solution of hot water
with 10% lemon juice to unblock the holes or wash in the
dishwasher. This will remove excess fiber build up (from
fruit or vegetables) which could be inhibiting the juice
flow.