Filter
Top Products
11
Wizz Stainless Plus (Chopper) – assembly & operation
10
To attach the plastic gear box, chopping
blade, chopper bowl and lid
Remove blending shaft from motor body as on
page 8.
The chopping blade is extremely sharp and
should be handled only by the upper plastic
section.
Note
Place the blade onto the base of the chopper bowl
(See Fig 1). Place the food inside the chopper bowl.
Do not exceed the maximum (MAX) marking.
Place the transparent lid onto the chopper bowl and
press down firmly to secure (See Fig 2).
Align the closed end of the gear box with the
corresponding part of the chopper bowl lid (See
Figure 3). In a clockwise direction, attach and lock
the motor body to the open end of the gearbox (See
Figure 4).
Ensure chopper bowl lid is dry with no water left
inside before re-attaching.
Always place the chopping blade onto the base
of the chopper bowl BEFORE placing food inside.
Do not lift the blade before the complete
chopping operation is finished.
Note
To use the chopper bowl
For food preparation tips and recipes refer to page 16
and the recipes section.
Ensure the chopper is completely and properly
assembled as detailed on this page.
1. Insert the plug into a 230/240V power outlet and
turn the power on.
2. Select a speed to turn the appliance on and start
the chopping blade.
3. When processing has finished, switch off the
motor by releasing the speed button, switch off
at the power outlet and remove the power plug.
6. Detach the motor body and gear box (refer to
instructions below). Remove the lid from the
chopper bowl. Carefully remove the chopping
blade and use a spatula to scrape off any
attached food back into chopper bowl.
Use a spatula to remove food from the
chopper bowl.
To detach the chopper bowl
Ensure the speed is released, power is turned off at
the power point and the appliance is unplugged.
In an anti-clockwise direction, unlock the motor body
from the gear box (See Fig 4). Lift the gear box from
the chopper bowl lid (See Fig 3).
Recommendations when using the Wizz
Stainless Plus with the chopper bowl
• Do not operate your Wizz Stainless Plus when the
chopper bowl is empty.
• The rubber surround around the base of the
chopping blade keeps the chopper bowl stable,
however it is recommended during processing to
hold the motor body with one hand and the
chopper bowl and lid with the other.
• When processing, cut food into uniform sizes to
ensure quicker, even and more consistent results.
• DO NOT process hard foods such as coffee, cereals
or chocolate in lumps, as damage to the blade
may result.
• DO NOT process boiling or hot foods in the
chopper bowl.
• NEVER remove the blade from the bowl before
food processing is completed.
• The Wizz Stainless Plus blends foods and liquids
rapidly, therefore it is easy to over process.
Remember to check food throughout
the operation.
4
2
1
3