Filter
Top Products
Page 17
PROGRAMMING THE BREWER (cont.)
SET NEW RECIPE (cont.)
8. Using (-) and (+), set the amount of brew water, in
ounces, to be dispensed for that particular batch
size.
9. When finished, press another batch size and re-
peat step 8 for that size. Continue setting all batch
sizes.
10. When finished setting all batch sizes, press and
release DONE. The display should read 3 BATCH
SIZES DONE?
11. If the three batch sizes are not correct, press and
release NO to return to the BREW OUNCES setup
screen and repeat steps 8 through 10. If the three
batch sizes are correct, press YES. This will advance
to the % BYPASS function. (Refer to % BYPASS
for description).
P2416
% BYPASS XX.X
(-) DONE (+)
3 BATCHES DONE?
NO YES
SET PULSE BREW?
NO YES
12. Using (-) and (+) set the amount of bypass water
(percentage) to be dispensed around the grounds
for that particular batch size.
13. When finished, press another batch size and repeat
step 12 for each batch to be set.
14. When finished setting each batch size, press DONE.
The display should read 3 BATCHES DONE?
15. If the three batch sizes are not correct, press and
release NO to return to the % BYPASS setup screen
and repeat steps 12 through 15. If they are correct,
press YES. This will advance to SET PULSE BREW.
(Refer to SET PULSE BREW for description).
16. To SET PULSE BREW, if setting pulse brew BY
EXAMPLE (brewing into a funnel) press YES and
proceed with the setup instructions for SETTING
PULSE BREW - BY EXAMPLE.
17. If setting pulse brew by ENTER TIMES (enter-
ing known times) press NO. The display should
read ENTER TIMES. Press and release YES and
proceed with the setup instructions for SETTING
PULSE BREW - ENTER TIMES. SET DRIP TIME.
(Refer to SET DRIP TIME for description). After
SET PULSE BREW has been accomplished, the
next function will be SET PREINFUSION. (Refer
to SET PREINFUSION function for description.
18. To SET PREINFUSION press YES in the SET PRE-
INFUSION screen to proceed. The display should
now read ON TIME and a batch light will be blink-
ing.
19. Using (-) and (+), set the amount of time the brew
water will initially presoak the grounds for that
particular batch size.
20. When finished, press another batch size and repeat
until all three batch sizes are set.
21. When finished, press DONE. The display should
now read OFF TIME and a batch light will be blink-
ing.
22. Using (-) and (+), set the amount of time the brew
cycle will delay (after the presoak cycle shuts off)
before resuming brewing.
23. When finished, press another batch size and repeat
until all three batch sizes are set.
ON TIME X:XX
(-) DONE (+)
OFF TIME X:XX
(-) DONE (+)
ON OFF
X:XX X:XX
DRIP TIME X:XX
(-) DONE (+)
3 BATCHES DONE?
NO YES
SET PREINFUSION?
NO YES
ADVANCES
TO NEXT
FUNCTION
5 SEC. DELAY
P2417
41343 080108