Filter
Top Products
Page 12
SPRAY OZ/M: XX.X
LP1-LP2 OZ XX.X
ENTER OZ XX.X
(-) DONE (+)
WaitingTilCycle 4
CYCLE x COMPLETE
CALIBRATE SPRAY
PRESS BREW START
CONTAINER READY?
QUIT YES
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
When the dispensing finishes, empty the decanter/server and
place back under brew funnel.
Select YES for calibration. Selecting QUIT will skip to level
probe calibration screen.
Press the "BREW START" button. Will perform the sprayhead
flow-rate calibration as well as the level probe calibration.
Brewer must not be bumped during calibration!
Machine will dispense volume between upper probe and
lower probe 4 times. (The total dispense will be about half of
a decanter)
Brewer must not be bumped during calibration!
Enter volume dispensed into container.
Use the (+) to increase the numeric value or (-) to decrease.
Displays sprayhead flow-rate and volume of water between
the upper and lower level probes.
Go to CAL
LP1-LP2
CALIBRATE LP1-LP2
NO YES
Allows you to perform calibration again if you want to verify
results.
Go to BREW
COUNTERS
Go to CAL
LP1-LP2
41154 041708