Filter
Top Products
13
SERVICE
AUGER DRIVE COMPONENTS (CONT.)
4. Disconnect the dispenser from the power supply.
If voltage is present as described, proceed to #5.
If voltage is not present as described, refer to the wir-
ing diagrams and check the dispenser wiring harness.
5. With the wires removed from the motor to be
tested. Check for continuity across the two ter-
minals on the bottom of the auger motor.
If continuity is present as described, reconnect the
wires to the terminals on the bottom of the auger
motor, the auger motor is operating properly.
If continuity is not present as described, replace the
auger motor.
Removal, Cleaning and Replacement
Hopper & Auger
1. Open the dispenser door and raise the top front
cover.
2. Lift the front edge of hopper assy (21) over the
tab on hopper support plate (20) and slide hop-
per assembly out the front of the dispenser.
3. Remove hopper lid (1) and empty product.
4. Pull off the ejector elbow (14).
5. Remove auger disc assy (2) by pulling agitator
support rod (4) towards agitator disc assy and
lifting agitator disc assy from hopper (10).
6. Remove auger (12) by pulling it out the front of
the hopper (10).
7. Remove auger drive shaft (5) by removing the
retaining clip (6) from auger drive shaft.
8. Slide washer (8) and auger drive shaft bracket
(7) off of the auger drive shaft (5).
9. Slide auger drive shaft (5) from auger drive shaft
bushing (3) and remove from hopper (10).
10. Remove locknut (9) from auger drive shaft bush-
ing (3) and remove auger drive shaft bushing
from hopper (10).
11. Wash components in a mild solution of dish de-
tergent using a bristle brush when needed.
12. Rinse and dry each item thoroughly.
13. Check for damaged or broken components, re-
place any if necessary and reassemble hopper
assy.
FIG. 2 AUGER DRIVE & HOPPER DISASSEMBLY
1. Hopper Lid
2. Agitator Disc Assy
3. Auger Drive Shaft
Bushing
4. Agitator Support Rod
5. Auger Drive Shaft
6. Retainer Clip
7. Auger Drive Bracket
8. Washer
9. Locknut
10. Hopper
11. Spring
12. Auger Wire
13. Auger Wire/Restrictor
(Optional)
14. Ejector Elbow
15. Auger Motor Mount-
ing Panel
16. Auger Motor Bracket
17. Auger Motor
18. Dust Seal
19. Shoulder Screw
20. Hopper Support plate
21. Hopper Assy