Filter
Top Products
28
SERVICE (cont.)
RINSE /RUN SWITCH
FIG. 24 RINSE/RUN SWITCH
P1452.40
Location:
The rinse/run switch is located on the right
side of the whipper motor mounting panel.
Test Procedures:
1. Disconnect the dispenser from the power source.
2. Check for continuity between center terminal and
the upper terminal with the switch in the “RUN”
lower position. Continuity must not be present
with the switch in the “RINSE” upper position.
If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Open the dispenser door.
2. Remove the facenut securing the run/rinse switch
to the whipper motor mounting panel.
3. Remove switch with wires attached from the back
side of the whipper motor mounting panel.
4. Disconnect the wires from the switch and dis-
card the switch.
5. Refer to Fig. 25 when connecting the wires to
the new switch.
6. Install new switch with wires attached through
the hole in the whipper motor mounting panel
and secure with facenut.
FIG. 25 RINSE/RUN SWITCH TERMINALS
P1456
BLK to Main
Wiring Harness
BLK from
Hopper Delay
Board #4
28364 011598