Filter
Top Products
29
SERVICE (cont.)
RUN/RINSE SWITCH
FIG. 23 RUN/RINSE SWITCH
P1199.45
Location:
The run/rinse switch is located on the right
side of the front panel.
Test Procedures:
1. Disconnect the dispenser from the power source.
2. Check for continuity between center terminals and
the upper terminals with the switch in the “RUN”
lower position. Continuity must not be present
with the switch in the “RINSE” upper position.
If continuity is present as described, the switch is
operating properly.
If continuity is not present as described, replace the
switch.
Removal and Replacement:
1. Open the dispenser door.
2. Remove the facenut securing the run/rinse switch
to the dispenser front panel.
3. Remove switch with wires attached from the back
side of the front panel.
4. Disconnect the wires from the switch and dis-
card the switch.
5. Referring to the illustration below (Fig. 24) re-
connect the wires to the new switch.
6. Install new switch with wires attached through
the hole in the front panel and secure with facenut.
FIG. 24 RUN/RINSE SWITCH TERMINALS
P1213
27591 111596