Filter
Top Products
43
12
11
9
8
7
SERVICE (CONT.)
Resistor (all 230V Models)
Removal and Replacement:
1. Disconnect the dispenser from the power source.
2. Disconnect the resistor from the relay and discard.
3. Install new resistor to the relay as shown below.
4. Return power to the dispenser.
FIG. 60 RESISTOR TERMINALS
P3864
FIG. 59 RESISTOR
Location:
The resistor is located on the relay at the electrical
component mounting bracket on the lower front of the
dispenser behind the splash panel.
Test Procedures:
1. Disconnect the dispenser from the power source.
2. Remove the resistor from the relay.
3. Check the resistance across the terminals of the
resistor with a ohmmeter. The indication must be
approximately 36k ± 5%.
4. Disconnect the dispenser from the power source.
If resistance is present as described, the resistor is
operating properly.
If resistance is not present as described, replace the
resistor.
49179 110613