Bunn LPG Coffee Grinder User Manual


 
5
C
O
A
R
S
E
-
F
I
N
E
B
U
N
N
INITIAL SET-UP/ADJUSTMENTS
The grind can be set from fine to very coarse. The grind may be adjusted for use in most commercial coffee
brewers. The following procedures should be used to make adjustments.
NOTE - A change in the burr adjustment will also change the amount dispensed. Any adjustment to the burrs should
be followed by an adjustment of the timer dials.
Burr Adjustment
1. Unplug the grinder and empty all beans from the hopper(s).
2. Plug-in the grinder, place funnel with filter into the funnel rails. Momentarily
press the Off/On/Start switch to the “START” (lower) position (with desired
hopper selected) and release, run a few grind cycles until all of the coffee in the
grind chamber is dispensed.
3. Remove the funnel with filter and carefully tip the grinder over on it’s back.
4. Place the Off/On/Start switch in the “START” (lower) position and, using the
grind adjustment key provided, slowly turn the adjusting screw in a clockwise
direction until a metallic whine is heard due to the rubbing of the grinding burrs. (It may be necessary to start
more than one grind cycle to obtain the sound).
5. Make a mark with a pen on the decal to note the position of the arrow on the grind adjustment screw.
6. The following settings approximately correspond to the CBC recognized grinds. All are referenced from the
arrow position marked in step #5.
FINE GRIND: Rotate the adjusting screw 7 hash marks in a counterclockwise direction.
DRIP GRIND: Rotate the adjusting screw 8 hash marks in a counterclockwise direction.
REGULAR (COARSE) GRIND: Rotate the adjusting screw 10 hash marks in a counterclockwise direction.
NOTE: Exact adjustment will vary according to bean roast or added flavoring.
P1073
P1035
27103.0000B 3/97 © 1996 BUNN-O-MATIC CORPORATION
SCHEMATIC WIRING DIAGRAM
LPG2E
NL1
BLK
RED
WHI
120 VOLTS AC
2 WIRE
SINGLE PHASE
60 HZ
GRN
3
AMP
2
3
4
5
6
1
10
7
8
9
TIMER ASSY.
GRN
WHI
BLU
YEL
WHI/BLK
BLK
RED
VIO
ORA
WHI
BLU
YEL
WHI/BLK
BLK
RED
VIO
ORA
OFF/ON/START
SWITCH
RED
RED
RED
GRN
SELECTOR
SWITCH
WHI
RED
RED
WHI
BLK
GRINDER
M
SLIDE GATES
RT
SOL
LT
SOL
(Hopper Slide
Gate Timer
Dial Wiring)
Right - Brown
Left - Orange
RED RED