Filter
Top Products
14
7) Place the empty cup or bowl back onto the drip tray grate and press the
COFFEE BREW BUTTON to begin a brew cycle.
8) When the cycle has finished, empty the cup. Repeat step 7 at least two more
times to remove the solution from the tank.
9) Clean the pod holder with a mild detergent and rinse thoroughly.
10) Proceed to the “Cleaning The Sprayhead/Seal” section.
CLEANING THE SPRAYHEAD/SEAL
1) Press the Power Switch into the off “O” position.
2) Unplug the brewer and allow it to cool down. (Minimum of 1 hour.)
3) After the unit has been allowed to cool, remove the pod holder and set aside.
4) Using your fingers, rotate the sprayhead/seal assembly
clockwise until the sprayhead and seal are removed.
NOTE: If the sprayhead and seal are separated, they must be
reassembled as they were when removed from the brewer.
CAUTION: Improper reassembly could result in personal
injury from scalding water.
NOTE: See “Assembling Sprayhead/Seal” (Page 14) &
“Inspecting Sprayhead Seal” (Page 15) for more information.
5) Clean the sprayhead and seal with a mild detergent and
rinse thoroughly.
6) Using your fingers, rotate the sprayhead/seal assembly counter-clockwise until
it is finger tight.
7) Replace the pod holder.
8) Plug in the brewer and press the POWER SWITCH to restore power to the
brewer.
ASSEMBLING THE SPRAYHEAD/SEAL
If the sprayhead and seal are separated during removal or cleaning, they must be
reassembled properly.
1) Identify the top of the seal. The top of the seal that seats
against the roof of the sprayhead ramp has a rough
ridge that can be felt by running your fingers across the
surface of the seal. The bottom is smooth.
2) Identify the top of the sprayhead. The top of the
sprayhead has a star pattern and a threaded hole where
the sprayhead attaches to the brewer.
3) While carefully stretching the seal, guide the sprayhead
into the channel of the seal. Make sure it is completely in
the channel.
When properly assembled, the sprayhead will slide easily
into the channel of the seal and will not cause any buckles in
the surface of the seal. If the sprayhead seems to be difficult
to seat, and you must stretch the seal more than a slight tug,
the assembly is not together correctly.
CAUTION: Improper reassembly could result in personal
injury from scalding water.
Top
Top
P2953
P2953
P2953
PERIODIC CLEANING/DESCALING (Cont.)
P3015