7
DEFINITIONS
COMPONENTS
• WATER RESERVOIR - Holds reserve water for brewing. The reservoir can be removed
and filled separately at a sink or other clean water source or by pouring water through
the slide lid. (Holds 46 oz. (1.7 L) to the maximum line.)
• SLIDE LID - The slide lid allows access to the reservoir. Water can be poured through the
opened lid and into the reservoir without removing the reservoir.
• POD HOLDER RELEASE BUTTON - Push to unlock and release the pod holder. When
there is power to the brewer, this button will illuminate red in color, showing the
trademark BUNN name. This light will go out during a brew cycle and when the
brewer has gone into Sleep Mode. (Refer to the “Features” section on page 8 for more
information.)
• BLUE (BREW) LIGHTS - Blue colored lights are located near the pod holder area and
light up to indicate that a brew cycle is in process.
• SPRAYHEAD SEAL - The seal keeps water under pressure from escaping, while a brew
cycle is in process. If leaks are present during a brew cycle, consult the “Troubleshooting”
section on page 16.
• SPRAYHEAD - Designed to distribute water evenly across the coffee pod or tea bag/pod
to extract the proper flavor.
• POD HOLDER INSERT - A color-coded, removable screen designed to allow proper flow
rates and steeping capabilities for the type of brew desired.
• POD HOLDER - Holds the coffee pod or tea bag/pod.
• DRIP TRAY GRATE - A removable part that allows any spilled liquid to drip through into
the drip tray.
• DRIP TRAY - Removable tray that is designed to catch any spilled liquid.
• POWER SWITCH - Turns on and off all electrical service to the brewer. This button is
only to be used when the brewer will not be used for several days. (In the “I” position
the power is on. In the “O” position the power is off.)
• VOLUME CONTROL SLIDE LEVER - Adjusts the amount of water dispensed through
the pod holder. Sliding it left will produce a smaller serving. Sliding it to the right will
produce a larger serving. The brewer will dispense approximately 4 to 12 oz. (118 to
355 ml) in one ounce (30 ml) increments.
• CONTROL PANEL - Controls for brewing coffee or tea and various indicators are located
on the control panel. (FIG. 2) See specific definitions below.
CONTROL PANEL
• COFFEE BREW BUTTON - Depress this button to brew a serving of coffee. Pressing it
again will cancel a brew cycle in process.
• REFILL WATER INDICATOR - If the water in the reservoir is running low, and either the
Coffee or Tea Brew button is pressed, this indicator will flash for a few seconds to show
that the water reservoir needs to be refilled. A brew cycle cannot be started until the
reservoir has been refilled.
• HEATING INDICATOR - This light indicates that the heater is bringing water up to
temperature. A brew cycle cannot be started until the indicator has gone out. (During a
brew cycle, this light will come on indicating the tank heater is warming the new water
entering the tank.)