Filter
Top Products
16
TROUBLESHOOTING
SITUATION EXPLANATION
Nothing happens when the
COFFEE BUTTON or TEA
BUTTON is pressed.
This is the first time you have used your
brewer.
The Initial Brewer Set-up procedure must be
performed first.
Please follow the directions
on page 9 before attempting to run a brew
cycle.
Your brewer is not plugged in.
Check to make sure the brewer is plugged
in and the POWER SWITCH has been turned
on. (The POD HOLDER RELEASE BUTTON
- also known as the BUNN Indicator - will
be illuminating red, indicating power to the
brewer.)
The HEATING INDICATOR is lit.
Wait until the indicator goes off before
pressing one of the brew buttons. The
brewer will not start a brew cycle until the
water in the internal tank is heated to the
proper temperature.
The POD HOLDER INDICATOR is lit.
Check to make sure the POD HOLDER is
inserted into the brewer.
If the POD HOLDER is inserted into the
brewer, carefully remove and replace the
POD HOLDER to ensure the POD HOLDER is
locked in place.
Listen for a clicking sound. The click
indicates that the holder has locked into
place.
The REFILL WATER INDICATOR is lit.
The reservoir has run low on water and
needs to be filled above the minimum mark
indicated on the side of the reservoir.