Filter
Top Products
9
INITIAL BREWER SET-UP
1. Remove the lid and
water reservoir.
(CAUTION: Do not place the brewer in a
sink or other water source.)
8. Place a mug or bowl that will
hold at least 14 fl. oz. (414
ml) onto the drip tray grate.
4. Replace the reservoir and
lid and close the slide lid.
9. Press and release
the coffee brew
button to fill the
internal water tank.
5. To ensure the Pod Holder
is locked in place, use
thumb to press the pod
holder release button to
eject the holder and then
press all the way in to
(CAUTION: Water may not immediately flow
from the brewer. Never remove pod holder
from brewer during a brew cycle.)
(CAUTION: You should hear a clicking sound
when the pod holder locks in place.)
6. Slide the volume
control lever to the
maximum setting.
7. Plug in the brewer
and turn on the
power switch.
11. Press and release
the coffee brew
button a second
time.
(CAUTION: Water should flow from the pod
holder. Wait until water drip out has finished
before removing the pod holder.)
P2901
P2904
P2903
P2907
P2907
P2952
P0214/2905
(NOTE: Wait for Heating Indicator to go out
before proceeding to Step #11)
You are now finished preparing the brewer
for it’s first use. Proceed to the “Brewing
Delicious Coffee Or Tea” section.
2. Thoroughly rinse the water reservoir.
3. Fill the reservoir to the
maximum line with
fresh cold water.
P3017
10. Empty any water in the mug or bowl and
place the mug back on the drip tray grate.
P2908