Filter
Top Products
18
TROUBLESHOOTING (Cont.)
SITUATION
EXPLANATION
The Pod Holder will not come
out of the brewer.
Water is appearing on the
counter around the base of the
brewer.
Water leaks out around the
sprayhead.
The pod in the POD HOLDER may have swelled
to a point where the holder does not slide out
easily.
Wait at least 10 minutes and then try
carefully removing the pod holder again.
CAUTION: Hot liquid may be present.
The WATER RESERVOIR has been removed
to be filled with water and was not seated
properly when it was replaced.
Remove the lid from the top of the brewer.
With firm, but not forceful pressure, press
down on both sides of the reservoir to
ensure that the seal in the bottom of the
reservoir seats properly. Replace the lid and
watch for additional water around the base
of the brewer. If a problem persists, contact
Customer Service. (Refer to page 20 or 22
for customer assistance.)
Replace a damaged seal or tighten a loose
sprayhead.
Refer to “Assembling The Sprayhead/Seal”
& “Inspecting The Sprayhead/Seal” sections
for detailed information on how to resolve
sprayhead leaks.
CAUTION: Wait for hot liquid to cool.