Filter
Top Products
Page 4
ELECTRICAL REQUIREMENTS
CAUTION - Do not connect the brewer to the power source until specified in Initial Set-Up.
MODELS OL15 & 20 require
2-wire, grounded service rated
120 volts ac, 15 or 20 amp re-
spectively, single phase, 60 Hz.
MODELS OL35 & RL35 require
3-wire, grounded service rated
120/208 or 120/240 volts ac, 20
amp, single phase, 60 Hz.
Electrical Hook-Up
Model OL15 has an attached cordset.
Models OL20, OL35, & RL35, proceed as follows:
CAUTION – Improper electrical installation will damage
electronic components.
1. An electrician must provide electrical service as
specified.
2. Using a voltmeter, check the voltage and
color coding of each conductor at the electrical
source.
3. Remove the top panel and rotate the control
thermostat knob fully counterclockwise to the
“OFF” position and replace the panel.
4. Remove the rear panel, feed the cord through
the strain relief, and connect it to the terminal
block.
5. Connect the brewer to the power source and
verify the voltage at the terminal block before
proceeding. Replace the rear panel.
6. If plumbing is to be hooked-up later be sure the
brewer is disconnected from the power source.
If Plumbing has been hooked-up, the brewer is
ready for Initial Set-Up.
MODELS OLA, RLA, OL35B &
RL35B require 2-wire, ground-
ed service rated 240 volts ac
or 200 volts ac, 20 amp single
phase, 50 Hz.
MODEL OL25B requires
2-wire, grounded service
rated 100 volts ac, 20 amp
single phase, 50 Hz.
32430 051512
L2 RED
L1 BLACK
200, 230 or
240V A.C.
CE REQUIREMENTS
• This appliance must be installed in locations where
it can be overseen by trained personnel.
• For proper operation, this appliance must be installed
where the temperature is between 5°C to 35°C.
• Appliance shall not be tilted more than 10° for safe
operation.
• An electrician must provide electrical service as speci-
fied in conformance with all local and national codes.
• This appliance must not be cleaned by water jet.
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowl-
edge, unless they have been given instructions con-
cerning use of this appliance by a person responsible
for its safety.
• Children should be supervised to ensure they do not
play with the appliance.
• If the power cord is ever damaged, it must be replaced
by the manufacturer or authorized service personnel
with a special cord available from the manufacturer
or its authorized service personnel in order to avoid
a hazard.
• Machine must not be immersed for cleaning.