Cascade TFO-10 Oven User Manual


 
F O R C E D A I R O V E N M A N U A L
Cascade TEK 5245-A NE Elam Young Parkway Hilllsboro Oregon 97124
Toll Free 888-835-9250 503-648-1818 FAX 503-648-1798 info@cascadetek.com www.cascadetek.com
REV 01.08
7
Section 4
PRECAUTIONS
4.1 These units have been designed with vents on top of the chamber. In order to
work effectively and safely, some precautions will need to be taken by the
operator.
A. In most applications, the vent will need to
be opened during drying or degassing for
best results.
B. THIS OVEN IS NOT DESIGNED TO
HANDLE COMBUSTIBLE GASSES
AND IS NOT AN EXPLOSION PROOF
UNIT. Do not place explosive, combustible, or flammable materials
into the chamber.
C. Some of the outgassed by-products may be hazardous or unpleasant to
operating personnel. If this is the case, the exhausts should be positively
ventilated to the outside and dealt with according to local regulations.
4.2 Do not operate near noxious fumes.
4.3 Do not place sealed or filled containers in the oven chamber.
4.4 Do not cut or remove the ground prong from the power cord.
4.5 Be sure that the power supply is of the same voltage as specified.
4.6 Disconnect the unit from the electrical source before proceeding to make any
electrical repairs or replacements.
4.7 If a mercury thermometer is used and breakage should occur, all spilled mercury
MUST be completely removed from the chamber before continuing operation.
4.8 This oven is NOT designed for use in Class I, II, or III locations as defined by the
National Electrical Code.
4.9 This oven is not intended, nor can it be used, as a patient connected device.