Filter
Top Products
F O R C E D A I R O V E N M A N U A L
Cascade TEK 5245-A NE Elam Young Parkway Hilllsboro Oregon 97124
Toll Free 888-835-9250 503-648-1818 FAX 503-648-1798 info@cascadetek.com www.cascadetek.com
REV 01.08
8
Section 5
CONTROL PANEL OVERVIEW
5.1 Power Switch: The main power switch on the control panel (green lighted I/O)
controls all power to the unit and must be in the I/ON position before any systems
are operational. The switch will be lighted when in the I/ON position.
5.2 Main Temperature Control: This controller consists of the digital display and
UP/DOWN arrow pads for inputting set point temperatures and calibration.
5.4 Over-Temperature Safety Thermostat: This control is marked with a graduated
dial. It is independent of the Main Controller and guards against any failure which
would allow the temperature to rise past the Main Controllers set point. This
allows continued operation of the oven until the problem can be corrected or
service can be arranged. It is not recommended that the unit be operated for
extended periods of time using only the Over-Temperature Safety as the
controller as temperature uniformity will suffer. See Section 6 on how to set the
Over-Temp Safety Thermostat.
5.5 Over-Temperature Safety Light: This pilot lamp is directly below the Over-
Temperature Safety Thermostat. The light will come on when the Safety
Thermostat has been activated and taken control of the oven temperature. Under
normal operating conditions this pilot lamp should never be on.
Power Switc
h
Over
-
Temperature Safety
Thermostat
Over
-
Temperature
Safety Light
Main Temperature
Controller