Filter
Top Products
34
FASTENING THE COOKTOP
Each cooker top is provided with an installation kit including brackets and screws for
fastening the top to fixture panels from 20-30 to 40 mm thick, figs. 6.11 (2 electrical
plates hob) e 6.12 (vitroceramic hob).
✓ Cut the unit.
✓ Stretch gasket “D” over the edge of the hole made, being careful to overlay the junc-
tion edges
✓ Turn the cooktop over and put tabs “A” (fig. 6.10) into the mountings, only tighten
screws “B” a few turns.
Make sure that the tabs are mounted correctly as shown in the figures 6.11 and 6.12.
Turn the tabs so that the cooktop can be put into the hole.
✓ Put the cooktop into the hole cut into the unit and position it correctly.
✓ Put tabs “A”; into place, tooth “C” of the tabs should go into the hole.
✓ Tighten screws “B” until the cooktop is completely secured.
✓ Using a sharp tool cut off the part of gasket “D” which protrudes from the cooktop.
20 mm min.
40 mm max.
B
D
A
C
30 mm min.
40 mm max.
B
D
A
C
Fig. 6.11
Fig. 6.12
A
A
A
A
Fig. 6.10