Filter
Top Products
Cleaning and Maintenance
OVEN DOOR
The inside window can be easily
removed fol cleaning by unscrewing
the two fixing screws (Fig. 24).
Attention: When cleaning the oven
do not take off the rubber door pack-
ing and do not over tighten the fixing
screws when refitting.
GENERAL CLEANING
Before cleaning, always disconnect
the electrical supply to the oven.
Do not use a steam cleaner
because the moisture can get into
the appliance thus make it unsafe.
CLEANING AND MAINTENANCE
We advise you to clean the appliance when it is cold, especially the enamelled sur-
faces. In order to maintain the condition of the enamelled parts, clean and wipe fre-
quently with hot soapy water.
Rub gently so as not to damage the surface. Never use abrasive cleaning products. Do
not leave acid or alkaline residues (lemon juice, vinegar, salt, tomato etc.) on the enam-
elled surfaces.
NOTE: Any cleaners such as spray or stick cleaners which are used on enamel must
have the VEDC (Vitreous Enamel Development Council) seal of approval and the man-
ufacturer’s instructions must be followed.
Figure 24
WARNING
When correctly installed, your product meets all safety requirements laid
down for this type of product category. However special care should be
taken around the rear or the underneath of the appliance as these areas are
not designed or intended to be touched and may contain sharp or rough
edges, that may cause injury.
Do not use harsh abrasive cleaners
or sharp metal scrapers to clean
the oven door glass since they can
scratch the surface, which may
result in shattering of the glass.
22