CDA SC309 Oven User Manual


 
How to install your oven
Ensure that air can flow freely around the housing area.
If the oven is being installed into a fully enclosed built under oven housing unit it may
be necessary to cut a small slot in the top of the plinth fitted under the unit.
Cut a section 400 mm wide and a minimum of 15 mm high to allow air to pass under
the unit.
Failure to allow adequate ventilation to the appliance may result in over heating or
damage to adjacent units.
560
591
594
594
540
20
555
min.
550
560
50
585
Figure 4
Lift the oven carefully into position on the shelf, taking
care NOT to lift it by the door handle. If you lower the
oven door, you will see 4 screw holes, 2 on each side
of the oven.
The oven should then be secured to the housing by
fitting screws into these holes.
Remember the housing should not be free standing
but secured to the wall and/or
adjacent fittings.
9