Cleveland Range 21CET8 Electric Steamer User Manual


 
6
c) Shutting Off Alarm/When Timer is Done
When the timer counts down to zero, the alarm sounds continuously, the generator
stops steaming, and steam flow to the cooking compartment gradually stops.
Press the START/STOP key to silence the alarm. The cooking time display returns to
the last time set. Either run this same setting again or clear and reset the timer.
1. TIMER Display.
This four-digit display indicates the minutes and seconds remaining
in the count down. The display reads from zero (00:00) to
99minutes and 99 seconds (99:99). It reads pause (PAUS) when
the Countdown is halted either by the START/STOP key or by the
Temperature compensating circuit.
2. Number Pad Keys.
These keys set the number of minutes and seconds in the timer
count down. Pressing the number keys 1 2 3 4 in this sequence,
sets the timer for 12 minutes and 34 seconds (12:34).
3. START/STOP Key.
This key starts and stops the timer. In TIMED mode the steaming
functions are linked to the timer. In MANUAL mode, the steaming
functions are independent of the timer.
4. CLEAR Key.
This key resets the timer to zero (00:00), after it has been stopped.
The timer must be zeroed by pressing this key before a new time
can be set.
5. TIMED/MANUAL Switch.
The TIMED/MANUAL switch selects the manual or timed Operating
mode. Pressing the MANUAL (bottom) end of the switch selects
the manual mode. Pressing the TIMED (top) end of the switch
selects the timed mode.
6. POWER ON Switch and Indicator Light
(SteamCraft Ultra 3 & 5) When the Red indicator
light is on, power is on to the unit and the control
panel.
7. POWER ON Switch and Indicator Light
(SteamCraft Ultra 10) “POWER ON” Control is
located below the top compartment control
panel. When the Red indicator light is ON,
power is ON to the unit and both control panels.
Figure 2-2 Electronic Key Pad Control Panel
CAUTION
Press switches with fingertips only. Do not use kitchen
utensils or anything sharp to operate the switches.
SteamCraft Ultra 10
Power ON Control
7
1
3
2
4
6
5
SteamCraft Ultra 3 & 5
Panel (Pictured)