Filter
Top Products
KEYPAD - SUMMARY DESCRIPTION
Detailed explanations are given on the pages that follow.
AUTOMATIC OPERATION MODE: (normal operation on power up)
VIEW: View Data: date, time, cycles, and each component weight.
Press VIEW,* to print data.
RCP: Enter and retrieve stored RECIPES.
BTCH: View BATCH data: Target Weight, Current Portion, Accumulated
Total, and Batch Count. CE = clear displayed field.
FAST: Run rapid FAST cycles after a normal weighed cycle.
TAG: Tag Work Order and Operator numbers to all reports.
EXIT: Press to EXIT all sequences from ALL MODES.
SET: Press to review or change settings.
CE: Press to display "raw signal" weight readout for 3 seconds.
MANUAL MODE: Press: "*"; then (11111) or your own 5 digit password.
OPER: Operate all devices manually; open and close valves.
TIME: Operate devices for a selected time period.
CAL: Operate devices to learn rate.
Above keys use 1 through 9, A, B, C, DUMP, MIX, HOLD, ALARM.
ZERO: Zero the tare weight with the bin empty.
FULL: Using known weights, enter gram weight to calibrate load cells.
*00 Clear DATA fields.
*99 Set flag to enable weight calibration of load cells.
PROGRAM MODE: Press: "*"; then (22222) or your own password.
SET: Enter settings if access in Automatic mode has been locked out.
PARA: View or change system parameters. Press PARA for next in list,
"*" for previous, SET for next table, VIEW for previous table.
STAR FUNCTIONS: Press * and two numbers for the following functions:
*02 Extrusion and Yield Control. *52 Double dump weigh bin.
*03 Four digit (xx.xx) settings. *54 Print cycle information.
*04 Simulate FOUR software. *66 GB/WSB I.D. number (1-255).
*05 Inhibit table clearing. *69 Regrind as second natural.
*11 DATE - TIME, real-time clock. *71 Color percent of blend.
*12 Move table from ROM to RAM. *72 Additive percent of blend.
*23 Move from RAM to EEPROM. *74 Stop, alarm MAX wt exceeded.
*32 Move from EEPROM to RAM. *75 Alarm on weight drop.
*14 Set types: REG, NAT, ADD, OFF. *77 Print parameters.
*25 ROM OK flag, "CE" to clear. *78 Change program mode PASSWORD.
*33 Special Alarms. *82 Precision Ratioing.
*44 End cycle - bin full. *87 VOLUMETRIC operation.
*45 Change MANUAL mode password. *88 Print display readout.
*47 Totalizer flag. *89 Select pounds, kilos.
*48 Dispense range xx.x to xxx. *98 Display raw weight number.
Use "*" key to select readout or toggle flags ON or OFF.
Page 29