Filter
Top Products
same load cells, the accuracy of these ratios is not
affected by zero or full scale errors.
STAR FUNCTIONS available in the MANUAL mode:
*00 Press (*,0,0) to CLEAR ALL DATA fields. These are the
material usage totals that are viewed with the VIEW key. If
you are tracking material usage, you should record these
numbers periodically but clearing these totals is entirely
optional and not necessary.
After VIEWING the data or printing of data using the VIEW,*
key sequence, a display of (00=CLEAR) will appear for 5
seconds. During this 5 seconds you may reset all data
fields to zero by pressing 00. Pressing any other key or
waiting 5 seconds will exit this sequence without clearing
data.
*99 Press (*,9,9) to set flag to enable Weight Calibration of
the Load Cells. Power On will always set this flag to OFF.
This flag must be ON before the load cell weight calibration
keys, ZERO and FULL WT, will function. With ON flag
displayed, press EXIT.
KEYPAD - PROGRAM MODE
In this mode, you may perform ALL of the functions available in MANUAL
mode, plus additional functions that alter the logic with which the
controller operates.
The PARA key operates in this mode.
STAR FUNCTIONS are available by pressing the "*" key and two numbers.
Just as with the MANUAL mode, you can enter this mode only when the
controller is between cycles. The sensor must be covered or the STOP
switch must be in the "STOP - END OF CYCLE" position. In the MANUAL
mode, no automatic dispensing will occur.
To enter this mode, press "*", then enter the correct password number.
The correct password supplied with the unit is "22222". To change this
to another 5 digit number of your choice, see (*78). When in the
PROGRAM mode, the letter "P" shows at the left end of the display.
The following PROGRAM functions are available in the PROGRAM mode.
PARAMETERS: Press the PARA key to display the table of operating
(PARA) parameters that reside in memory. There are 13 separate
groups of parameters. The first group is the GENERAL group
and contains 20 GENERAL parameters. The other 12 groups are
the COMPONENT groups and contain 13 COMPONENT parameters
each.
A FULL EXPLANATION of each PARAMETER can be found in the
next section: EXPLANATION of PARAMETERS.
Page 37