Filter
Top Products
Version 1.0 Page 22
INSTALLATION / FREESTANDING UNIT / VENTING
1. After positioning the Little Rascal in its final position, proper flue venting must be installed
according to local and national codes. The LR-01 is a rear vented unit and flue vent pipe can
be run directly from the rear of the unit. Proper venting can be achieved by installing 3” TYPE
PL double wall vent pipe according to code requirements. Country Flame requires the use of
4” flue vent pipe if lengths of ten feet or greater are to be used in a specific installation. Pellet
flue pipe manufacturers’ instructions should be consulted for detailed installation instructions
of their product. These same manufacturers provide detailed drawings of venting
configurations, which meet or exceed code requirements. This information is available from
hearth dealers or can be downloaded from specific websites.
FOLLOW ALL VENT MANUFACTURER’S VENTING INSTRUCTIONS.
INSTALLATION DRAWINGS ARE FOR ILLUSTRATION PURPOSES ONLY.
WARNING: Operation of the Little Rascal Model LR-01 is dangerous when not connected to a
properly installed; code approved, and maintained flue pipe system.
2. The venting of this unit should NOT be connected to a flue serving another appliance.
3. At least a 3” clearance is required from all combustibles to the vent pipe, when using required
TYPE PL double wall vent pipe with stainless steel liner. This includes the area(s) where the
pipe passes through the roof. This clearance is generally met by installing flashing in roofs and
fire stop spacers between floors and ceilings. A thimble is needed for through wall
applications. Do not install a flue damper in this system.
4. Install the vent pipe directly onto the vent adaptor on the back of the unit. Be sure to push
firmly into position. Each flue pipe joint needs to be joined tightly with at least (3) sheet metal
screws and sealed with RTV silicone or aluminum flue tape. Air tight venting is required of
each flue pipe joint.
NOTE: IT IS RECOMMENDED, BUT NOT REQUIRED (EXCEPT IN MOBILE HOMES),
THAT INSTALLATIONS USE OUTSIDE COMBUSTION AIR FOR THE PELLET STOVE.
IF ROOM AIR IS USED FOR FRESH COMBUSTION AIR, A BAROMETRIC AIR VENT
SHOULD BE INSTALLED WITHIN A HOME TO MONITOR AND ENSURE ADEQUATE
AIR FLOW.
5. When using outside air, the metal rigid or flexible inlet pipe should have a mesh screen to
prevent rodents or birds blocking the pipe, also an elbow or shield should be used to prevent
prevailing winds from blowing directly into the air intake. For best efficiency, locate air inlet
24” (607mm) or more from exhaust vent pipe.