Filter
Top Products
Version 1.0 Page 27
INSTALLATION / INSERT UNIT / POSITIONING
1. The LR-01 insert is designed to be inserted into an existing masonry fireplace or zero clearance
box. The suitability of the existing firebox needs to be determined. You should insure that the
heater is kept out of any traffic paths in the room, away from curtains, drapes or any other
combustibles. You should also check that the existing fireplace was placed in a position where
heat will be evenly distributed throughout the room.
2. If the existing fireplace is found to be suitable, the LR-01 may be installed using zero
clearance.
3. While installing the LR-01, verify that the location will not interfere with the circulation
airflow. The unit draws air from the grills on both sides of the unit.
4. The heater should be installed in such a manner so that the front of the unit remains unblocked.
This will allow for needed service and maintenance to the unit, and provide access to the
firepot cleanout.
Mantel or Combustible
CLEARANCES FOR INSERT:
B
DIMENSIONS:
A = 3”
B = 6” A
C = 6”
C
FIGURE 7: INSERT MINIMUM CLEARANCES
Side Wall
INSERT
Hearth Extension