Filter
Top Products
3
SpeCIaL Cord Set
InStruCtIonS
A short power-supply cord is provided to
reduce the risks resulting from becoming
entangled in or tripping over a longer cord.
Longer extension cords are available and
may be used if care is exercised in their use.
If a long extension cord is used, the marked
electrical rating of the extension cord must
be at least as great as the electrical rating of
the appliance. The extension cord should be
a grounding-type 3-wire cord, and the
longer cord should be arranged so that it will
not drape over the countertop or tabletop
where it can be pulled on by children or
tripped over.
notICe
If you have a
diecast metal unit,
for your protection
it is equipped with
a 3-conductor cord
set that has
a molded 3-prong
grounding-type
plug, and should
be used in combi-
nation with a prop-
erly connected
grounding-type
outlet as shown
in Figure A.
If a grounding-type outlet is not available, an
adapter, shown in Figure B, may be obtained
so that a 2-slot wall outlet can be used with
a 3-prong plug. As shown in Figure C, the
adapter must be grounded by attaching its
grounding lug under the screw of the outlet
cover plate.
NOTE: Do not remove the grounding
prong.
CAUTION: Before using an adapter, it must
be determined that the outlet cover plate
screw is properly grounded. If in doubt,
consult a licensed electrician. Never use
an adapter unless you are sure it is
properly grounded.
Note: Use of an adapter is not permitted in
Canada.
Important unpaCKIng
InStruCtIonS
1. Place the box on a large, sturdy, flat
surface.
2. Remove the instruction book and any
other literature.
3. Turn the box so that the back side of
the brewer is down and slide the
coffeemaker from the box.
4. After removing the brewer, place the
box out of the way and take the side
pulp molded inserts away.
5. Remove the polybag covering the brewer.
We suggest you save all packing materials
in the event that future shipping of the
machine is needed. Keep all plastic bags
away from children.
WARNING
rISK of fIre or eLeCtrIC SHoCK
do not open
WarnIng: to reduCe tHe rISK of fIre or eLeCtrIC SHoCK,
do not remoVe CoVer (or BaCK)
no uSer-SerVICeaBLe partS InSIde
repaIr SHouLd Be done BY autHorIZed SerVICe perSonneL onLY
A.
Circuit Grounding
Conductor
Connected
Properly
Grounding
Prong
B.
Adapter
Grounding Lug
C.
Cover
Mounting
Screw
Cover of
Grounded
Outlet Box