Filter
Top Products
10
Air-2
EUROCHEF - PRO WALL HOOD
• Secure the Wood Bracket to 2 or more vertical studs, using
at least 2 of the 4 supplied long screws.
IMPORTANT: Screws must penetrate at least 1-1/2" into verti-
cal studs. Countersink screws into support.
AFFIXING THE HOOD MOUNTING SCREWS
IMPORTANT: FRAMING MUST BE CAPABLE OF
SUPPORTING UP TO 150 LBS
3
2
T
I
M
E
R
TIMER
1
Centerline of
Installation Space
24
Test Duct Cover Fit (do not install Duct covers)
• Place duct covers or recirculating cover over the top of the
hood to check for gaps.
• Confirm that the ceiling gap, if any, is less then 3/8”.
• If gap is greater than 3/8", OR if duct covers do not fit, it is
necessary to remove, re-measure and reinstall the Wood
Bracket.
Hang Hood On Wood Bracket
• Lift the hood and hold close to the installation location. Route
house wiring through the knockout and into the junction box.
• Place the hood over the Wood Bracket. Be sure the mount-
ing screws engage the keyhole slots in the back of the hood.
• Check to be sure the hood is level and centered.
• Use midpoint arrow in back of hood to confirm horizontal
position.
STEP 3A: INSTALL HOOD ONTO WALL (see enclosed template)
SKIP THIS STEP IF INSTALLING BENEATH A SOFFIT OR CABINET, GO TO STEP 3B.
Original Mounting
Screws as Shipped
x
1
5/16”
2”
x
24”
30”
36”
48”
x
8”
11”
14”
20”
• Insert hood mounting screws in the Wood Bracket at the
locations shown in the diagram, so screws protrudes 1/4".
This 1/4” gap will provide clearance to hang the hood.
• Affix enclosed paper template to wall.
• From the line indicating the bottom of the hood, measure
17” up and draw another line for the location of the Wood
Bracket. See illustration.
• Locate at least 2 vertical studs at the Wood Bracket.
• Center the supplied Wood Bracket, left to right and below
the marked line.