Filter
Top Products
13
Air-2
EUROCHEF - PRO WALL HOOD
• Use screws removed in Step 2 to re-install Filter Frame, per
photograph.
STEP 7: TIGHTEN - HANGING SCREWS
STEP 8: RE-INSTALL THE FILTER FRAME
• With Filter Frame still removed from Step 2
• Adjust hood up to eliminate any gaps at ceiling. Tighten
hanging screws.
• Add (2) more security screws + Washers at wood bracket.
• IMPORTANT: If Installing optional Backsplash Kit install this
kit BEFORE installing wall anchors
(see instruction with kit)
Install Bottom Wall Anchors
• Drill 1//8" pilot holes into the two lower mounting holes. Enlarge
the holes if they did not enter studs to 3/8".
• Install (2) or (3) wall anchors at bottom of hood.
• Remove anchor screws and add a flat washer provided. Drive
screws into anchors and tighten.
• If a Wood Stud was discovered at wall anchor locations use
80mm Wood Screw supplied with Washer (instead of Wall
anchor). Drive screws and tighten.