Filter
Top Products
6
CAST IRON STOVE AND BURNER SYSTEM
106706
SUN VALLEY STOVE COMPANY
For more information, visit www.desatech.com
CAST IRON STOVE
AND B-VENT
BURNER SYSTEM
ASSEMBLY
Continued
9. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Fig-
ure 9, page 5 and Figure 11). Use an
adjustable wrench or a 12mm socket
to fasten step bolt. Tighten step bolt
until snug. Make sure door moves
freely.
10. Install door catch bolt (M8 x 1.25-55mm
with two M8 hex nuts) into threaded
hole on stove body (see Figure 9, page
5). Use an adjustable wrench or a 12mm
socket. The catch bolt has two hex nuts
attached to it (see Figure 12). The top
nut is a bolt stop and the bottom nut is
for door leveling adjustment.
11. Check general catch bolt alignment
with door claw. Make final adjustment
and door leveling after stove is in nor-
mal standing position (see Figure 12).
12. Carefully lift stove back up on its four
attached legs.
13. Remove 2 bolts from bottom of stove
and one from the top of the stove to
remove the front panel assembly (see
Figure 13). Save bolts.
14. Lay the front panel assembly face down
on a protected surface. Remove the two
screws that hold the front plate onto the
front surround plate (see Figure 14).
Save these screws.
15. Remove the seven screws and washers
that hold the screen onto the front sur-
round plate. Discard these screws,
washers, and screen. They are for vent-
free use only (see Figure 14).
16. Replace the two screws from step 14
to reassemble the front plate and the
front surround plate. Set this assembly
aside until stove heater has been in-
stalled, logs have been placed inside of
heater, and glass door to heater insert
has been replaced.
17. Remove the two screws that secure the
metal plate located across the front sec-
tion at the top of the stove body (see Fig-
ure 15). Discard these screws and metal
plate. They are for vent-free use only.
Figure 13 - Removing Front Assembly
Figure 14 - Removing Screen from Front
Assembly
Figure 15 - Removing Metal Plate from
Stove Body
Figure 10 - Attaching Stove Legs
Bottom Of
Stove Unit
Leg
Bolt
Washers
Figure 11 - Attaching Lower Stove Door
Panel
Stove Door
Panel
Door Hinge
Step
Bolt
Threaded
Hole
Bolt
Shoulder
Front
Assembly
Bolt
Stove
Body
Screw
Stove Body
Metal
Plate
Screws
Front
Surround
Plate
Front Plate
Screen
Screw with
Washer
Bolt
Stop
Adjusting
Nut
Catch
Bolt
Door
Door
Claw
Figure 12 - Catch Bolt and Door Claw
Orientation