Filter
Top Products
POWER MANAGEMENT
The power management divides the pow-
er between two cooking zones in a pair
(see the illustration). The Power function
increases the power to the maximum level
for one cooking zone in the pair and de-
creases the power in the second cooking
zone. The display for the reduced zone
changes between two levels.
POWER MANAGEMENT FOR
THE RIGHT COOKING ZONES
AND THE TOP OVEN
The right cooking zones and the
top oven use the same energy
source (the same electrical phase)
when they operate at the same
time. The power management
prevents a circuit overload.
The more power the top oven uses during
its operation, the less is available for the
right cooking zones. When a zone cannot
use the full power, the display for the
zone changes between the two levels.
TIMER
Use it to set an automatic switch-off time
for a cooking zone.
1.
Set the cooking zone. Touch again
and again until the indicator for the
necessary cooking zone comes on.
You must set the cooking zone
before you activate the timer.
2.
Set the heat setting for the cooking
zone. You can also set it after you ac-
tivate the timer.
3.
To activate the timer or change the
set time, touch + or - on the hob con-
trol panel. The maximum time you
can set is 99 minutes.
The indicator of the cooking zone
flashes slowly. The timer starts to
count down.
4.
To see the remaining time, touch
again and again until the indicator for
the necessary cooking zone flashes
quickly. The display shows the re-
maining time.
When the set time ends, 00 flashes
and an acoustic signal sounds. The
cooking zone deactivates.
5.
Touch to stop the signal.
To deactivate the timer before the
set time is completed, set the
cooking zone with
and touch -.
The remaining time counts down
to 00. The indicator of the cook-
ing zone goes out.
You can use the timer as a Minute Minder
when the cooking zones do not operate.
To do this, set the cooking zone and acti-
vate the timer but do not set the heat set-
ting.
STOP AND GO
The Stop and Go function sets all
cooking zones that operate to the lowest
heat setting (
).
This function does not deactivate the tim-
er function.
•
To activate this function, touch
. The
display shows the symbol
.
•
To deactivate this function, touch .
The display shows the heat setting that
you set before.
When the Stop and Go function
operates, you cannot change the
heat settings.
ENGLISH
11