Filter
Top Products
there only heat-resistant accessories (if
applicable).
• Do not cover oven steam outlets. They
are at the rear side of the top surface (if
applicable).
• Do not put anything on the hob that is
liable to melt.
• If there is a crack on the surface, dis-
connect the power supply. There is a
risk of electric shock.
• Do not put heat-conducting materials
(e.g. thin metal mesh or metal-plated
heat conductors) under the cookware.
Excessive heat reflection can damage
the cooking surface.
• If you have an implanted pacemaker,
you must keep your upper body a mini-
mum of 30 cm away from the induction
cooking zones while they operate.
• Do not use the appliance during a pow-
er cut.
CARE AND CLEANING
• Before maintenance, make sure that
the appliance is cold. There is a risk of
burns. There is a risk that the glass pan-
els can break.
• Keep the appliance clean at all times. A
build-up of fats or other foodstuff can
result in a fire.
• Regular cleaning prevents the surface
material from deteriorating.
• For your personal safety and the safety
of your property, only clean the appli-
ance with water and soap. Do not use
flammable products or products that
can cause corrosion.
• Do not clean the appliance with steam
cleaners, high-pressure cleaners, sharp
objects, abrasive cleaning agents, abra-
sive sponges and stain removers.
• If you use an oven spray, follow the in-
structions from the manufacturer. Do
not spray anything on the heating ele-
ments and the thermostat sensor (if ap-
plicable).
• Do not clean the glass door with abra-
sive cleaning agents or metal scraper.
Heat resistant surface of the inner glass
can break and shatter.
• When the door glass panels are dam-
aged they become weak and can break.
You must replace them. Contact the
service centre.
• Be careful when you remove the door
from the appliance. The door is heavy.
• Bulb lamps used in this appliance are
special lamps selected for household
appliances use only. They cannot be
used for the full or partial illumination
of a household room.
• If it becomes necessary to replace the
lamp use one of the same power and
specifically designed for household ap-
pliances only.
• Disconnect the appliance from the
power supply before the replacement
of the oven lamp. There is the risk of
electrical shock. Cool down the appli-
ance. There is a risk of burns.
• Do not clean catalytic enamel.
SERVICE CENTRE
• Only an approved engineer can repair
or work on the appliance. Contact an
approved service centre.
• Use only original spare parts.
DISPOSAL OF THE APPLIANCE
• To prevent the risk of physical injury or
damage:
– Disconnect the appliance from the
power supply.
– Cut off the mains cable and discard
it.
– Discard the door catch. This prevents
children or small animals from being
closed inside of the appliance. There
is a risk of suffocation.
6
www.aeg.com